Dinopedia
Advertisement


Caulkicephalus
Rey caulkicephalus
An artist's illustration of Caulkicephalus trimicrodon
Scientific classification
Kingdom: Animalia
Phylum: Chordata
Order: Pterosauria
Suborder: †Pterodactyloidea
Family: †Ornithocheiridae
Genus: Caulkicephalus
Type species
Caulkicephalus trimicrodon
Martill et al., 2005

Caulkicephalus is a genus of pterosaur belonging to the Pterodactyloidea that hails from the Isle of Wight off the coast of England.


The smaller sized teeth were placed in a constriction of the snout, which thus had a broader end with larger teeth, a so-called "prey grab", usually interpreted as an adaptation to catch slippery prey such as fish.

The posterior skull fragment, a braincase which is rather damaged, shows on its top the base of a parietal crest, probably pointing towards the back. It seems to have been separate from the snout crest.

Discovery and naming[]

Between 1995 and 2003 bone fragments of an unknown pterosaur were found at the Yaverland locality near Sandown. The discoveries were made in or from a brown clay layer from the Wessex Formation of the Wealden Group, stemming from the Early Cretaceous (Barremian age, about 130 million years ago).

In 2005 a new genus was named and described by Lorna Steel, David Martill, David Unwin and John Winch. The type species is Caulkicephalus trimicrodon. The genus name is a translation of "Caulkhead", a traditional nickname for Isle of Wight residents, partially derived from Greek kephale, "head". The specific name, trimicrodon, means "three small teeth", in reference to the dentition.

The holotype is IWCMS 2002.189.1, 2, 4: three pieces, more or less contiguous, of the front part of a snout. As paratypes have been referred: IWCMS 2002.189.3, a partial posterior skull roof; IWCMS 2003.2, a left quadrate; IWCMS 2003.4, a possible partial jugal; ICWMS 2002.237, a 44 millimetres long fragment of the first phalanx of the wing finger; IWCMS 2002.234.1-4, four, together 245 millimetres long, contiguous fragments of a first phalanx; IWCMS 2002.233, a possible distal end, 64 millimetres long, of a second phalanx; IWCMS 2002.236, a fragment of the shaft of possibly the fourth phalanx; and IWCMS 2003.3, a probable fragment of a hindlimb bone. The fossils have only been slightly compressed.

The snout fragments have a combined length of 290 millimetres. On the snout top the base of a crest is visible, not quite reaching its rounded tip. The teeth have, apart from some replacement teeth present deep in the jaw, been lost but their number, orientation and size can be inferred from the tooth sockets, which however are partly missing at the right side. These are oval and slightly elevated above the jaw bone. The first two tooth pairs were pointed somewhat to the front; the teeth more to the back pointed more sideways; the most posterior preserved stood perpendicular to the jaw. The teeth increased in size until the third pair which was the largest. The fourth pair was equal to the first but the fifth, sixth and seventh pairs were markedly smaller, less than half in size; it is this feature which is recalled by the specific name. Pairs eight, nine and ten again equaled the first. After a narrow hiatus between the second and third snout fragment four tooth sockets are present at each side of the latter, but these are not placed in opposite pairs. The number of teeth in the upper jaw thus seems to have been at least fourteen.

Description[]

The layer the fossils were found in, does not consist of marine sediments, but contains land plant debris; this is seen as an indication of a more terrestrial habitat. David Martill estimated Caulkicephalus had a wingspan of around 5 metres (16.5 ft).

Classification[]

Caulkicephalus was, by the describers, assigned to the Ornithocheiridae in view of the narrowing in the middle of the snout. The snout crest was seen as an indication it belonged to the more general Ornithocheiroidea sensu Unwin, whereas the parietal crest was suggested to have been a synapomorphy, a shared new feature, of the more narrow group of the Euornithocheira. Unique characters of the species itself, its autapomorphies, are the details of its dentition, the downwards and backwards running suture between the praemaxilla and maxilla, and the fact the median ridge of the palate begins (or ends) at the ninth tooth pair.

In the Media[]

Gallery[]

Caulkicephalus/Gallery

See also[]

Advertisement